Local Reviews
for Glenpool, OK
Our Reviews by City
Great Service
Kindell - Glenpool, OK 74033
Service was amazing, quick, and efficient. Prompt responds time for scheduling. 10/10 would recommend
Caleb P.
Preformed yearly air conditioning maintenance on a 2010 Trane system. Checked the refrigerant level system’s components and washed the coil. System looks good at this time no problems where found at this time.
Caleb P.
AC maintenance visit. Performed a yearly 3 system air conditioning maintenance all three systems looked good at this time. Checked all safety’s refrigerant levels and indoor components. The indoor air quality test looks good aswell.
Caleb P.
Technicians performed a Friends and family club a/c maintenance on two Lennox systems. We checked all motors, both compressors, contactors, capacitors, refrigerant, cleaned out the drains, washed out the condensers and cleaned out the washable filters.
Caleb P.
Installed a whole home Apco-x air purifier to provide the home with pure air. Also prepaid for the duct cleaning that will be done 3/30 at 1 PM.
Caleb P.
Preformed yearly furnace maintenance on a Trane furnace. System looks good aswell as the IAQ report was green. Recommend installing a air purifier and a duct cleaning to help with the asthma and health in the home.
Ryan H.
Furnace maintenance visit for a friends and family club member. Performed full heating maintenance checklist: Checked all the electrical motors, manifold gas pressure, capacitor, and static pressure on the 15 year old Goodman 80% furnace. Cleaned the flame sensor and drain line. Inspected the flue pipe, all the safeties, delta T, heat exchanger, and overall performance of the system.
Ryan H.
Heating repair Service call. Customers thermostat was blank. Found the blower motor running and a flame roll out switch was tripped. The gas pressure on the manifold was abnormally high. Our new friends and family member will get a furnace maintenance tune up to get a good look at the heath of the entire system.
Caleb P.
Air conditioning repair visit. Arrived to find the unit tripped on a open pressure switch fault. Performed ac repair, found a kinked hose re routed the hose and insure proper operation the system is heating at this time.
Caleb P.
Found bad blower motor installed portable a/c for the weekend.
Chris V.
Service call Customer has a bad dust problem, The Blower motor assembly and Blower cabinet is super dirty and Dusty, as well as the Supply and return box are pretty dirty, Technician didn’t find any duct leaks, Technician recommended Getting a Duct Cleaning, Several Indoor UV Air Purification options to help eliminate The Dust and dirt particles flying thru the airflow, also eliminating all Bacterias, Allergens, Airborne Viruses, As well as Black Substance growth that Build up and grow within the HVAC systems.
Chris V.
Single System Furnace Tune Up, Technician Checked all safeties as well as every components proper operation to verify proper Heating operation in the following winter months, Technician also offered several options to help eliminate any Bacteria’s, Airborne Viruses, Allergens, as well as eliminate and prevent Black substance growth thru out the HVAC System, Also offered Surge Protector to prevent Power surges and power outages from damaging the internal Mother board and other electrical components within the furnace, System looks great at this time.
Ryan H.
Customer was getting no heat. Identified a loose connection on the heat sensor. Completed furnace repair and unit is now operating correctly.
Ryan H.
Technician arrived for a service call no heat. Found a frozen drain line not allowing the pressure switch to close. Thawed the line and got the high efficiency Trane furnace back up and going.
Chris V.
Service call No Heat, Technicians arrive to the system working as it should, Technicians adjusted the Heat swing from 4 degrees to 2 degrees, Customer said it was 71 in home and put the stat at 74 and the heater wouldn’t come on, Technicians arrive turn it to heat and the system fired right up. Will call u if anything happens again.
Caleb P.
Preformed yearly furnace maintenance system looks good at this time. Did find the gas valve loose and leaking gas tightened the valve and insured no gas leaks are present.
Chris V.
14 SEER AC with Single Stage Furnace, Installed new full system, installed new Filter base, Filter size- 1 16x25x1, Installed UV Air Purification Bulb, Ran a new drain line, Reconnected to existing copper lines, High Voltage, Low voltage, Supply plenum and return plenum, Flue Pipe, Gas Pipe, Brought entire system up too code, Checked and Adjusted gas manifold pressures, Didn’t check refrigerant levels being the temperature outside, We’ll be back in the spring to checked that, Other than that system works great.
Chris V.
Installed New Full A/C System in Gelnpool OK
Caleb P.
Found the unit trying to spark but would shut off after two clicks. Found a home made jumper wire resting on the board. Removed the wire and the system is running cycled the system several times and the unit came on every time.
Ryan H.
Technician arrived to the furnace not firing off. Found the hot surface igniter receiving voltage but not glowing. Removed to igniter to find a crack. Replaced the broken igniter and got the system up and going.
Ryan H.
Service call for a no heat. Technician found a failed hot surface igniter and replaced it to get the 31 year old Goodman furnace back up and running.
Caleb P.
Checked the furnace everything is fine at this time no carbon monoxide or gas leaking.
Caleb P.
Reinstalled a rooftop package unit to fix all the problems in Glenpool
Ryan H.
Follow up to check refrigerant levels at an install earlier this week in pecan estates in Glenpool.
Caleb P.
Service call no cool found bad blower motor in Glenpool
Caleb P.
Service call no cool found bad condenser fan motor in Glenpool
